Year 2004, sometime the Luxoom Company (Berlin) that created the Events for Siemens called Fernando Toma when they have to carry out certain mission impossible. In this case the mission was to control 5 columns that were equipped with revolving LED panels. (see simulation hi did at this time with 3DS4)
His job was to stay behind the company that would build these columns and give them the necessary directions so that hi can then programming their turns. His other task was to give the graphics compartment the available speeds and times according to how many degrees they turned, however the maximum available were 540 degrees because the transmission cables would break. Not being stepping motors the task was truly co-revving. Hi solved the problem by equipping a camera on the revolving column (see Video speedtest), resuming its behavior according to the speed, these parameters then hi introduced them in an Exel Table (see Exel Screenshot that hi programmed exclusively at the Bottom of this Page). This Exel document was then used from the graphic compartment as a storyboard to create animated content and of course also for his personal use during the programming of the 13 rotations LED panels by using 5 computers synchronized via Timecode, the software used was: Easy, Electrosonic Company.